آمار
| تعداد نشریات | 22 |
| تعداد شمارهها | 485 |
| تعداد مقالات | 5,045 |
| تعداد مشاهده مقاله | 9,290,946 |
| تعداد دریافت فایل اصل مقاله | 6,135,385 |
Investigation on Grease Elastohydrodynamic Lubrication | ||
| Journal of Stress Analysis | ||
| دوره 5، شماره 1، آذر 2020، صفحه 49-56 اصل مقاله (3.77 M) | ||
| نوع مقاله: Original Research Paper | ||
| شناسه دیجیتال (DOI): 10.22084/jrstan.2020.21222.1137 | ||
| نویسندگان | ||
| A. Torabi* ؛ M.H. Alidoosti | ||
| Engineering Department, Shahrekord University, Shahrekord, Iran. | ||
| چکیده | ||
| Lubrication as a friction reduction technique has been used in variety of mechanisms and machines. The contacting surfaces depart from each other by the pressure produced in lubricant due to surface wedge shape. In some applications pressure is such high that deforms the contacting surfaces and more space is provided for the lubricant. Increasing the film thickness leads to misestimating of friction coefficient. Greases are usually used when the lubricating area is unreachable easily or there is not enough space for oil recirculation. In this paper, Herschel–Bulkley's model was used for isothermal non-Newtonian grease lubrication under point contact elastohydrodynamic condition. A good agreement between experimental and simulation results is shown. The effect of different type of grease is compared according to lubricant film thickness and friction coefficient. Results show that threshold yield stress does not significantly affect tribological parameters but the power law exponent does. Higher load and lower entraining velocity cause thinner film as well as higher friction coefficient in spite of the grease type. | ||
| کلیدواژهها | ||
| Elastohydrodynamic؛ Lubrication؛ Grease؛ Friction | ||
| مراجع | ||
|
[1] C.H. Venner, M.T. van Zoelen, P.M. Lugt, Thin layer flow and film decay modeling for grease lubricated rolling bearings, Tribol. Int., 47 (2012) 175-187. [2] T. Otsu, Y. Nagata, J. Sugimura, R. Glovnea, Cavitation Phenomena in Pure-Sliding Grease EHL Films, In: American Society of Mechanical Engineers, Tribology Division, TRIB, San Francisco, California, USA, (2010) 127-129. [3] P.M. Lugt, A review on grease lubrication in rolling bearings, Tribol. Trans., 52(4) (2009) 470-480. [4] G.E. Morales-Espejel, P.M. Lugt, H.R. Pasaribu, H. Cen, Film thickness in grease lubricated slow rotating rolling bearings, Tribol. Int., 74 (2014) 7-19. [5] J.A. Greenwood, J.J. Kauzlarich, Inlet shear heating in elastohydrodynamic lubrication, J. Lubrication Tech., 95(4) (1973) 417-423. [6] W. Jonkisz, H. Krzeminski-Freda, The properties of elastohydrodynamic grease films, Wear, 77(3) (1982) 277-285. [7] J. Cheng, Elastohydrodynamic grease lubrication Theory and Numerical Solution in Line Contacts, Tribol. Trans., 37(4) (1994) 711-718. [8] J. Sugimura, M. Akiyama, Study of non-steady state grease lubrication with fluorescence microscope, In: G. Dalmaz, A.A. Lubrecht, D. Dowson, M. Priest (Eds.) Tribology Series, Elsevier, (2001) 285-294. [9] X. Lu, M.M. Khonsari, An experimental study of grease-lubricated journal bearings undergoing oscillatory motion, J. Tribol., 129(3) (2007) 640-646. [10] X. Lu, M.M. Khonsari, An experimental investigation of grease-lubricated journal bearings, J. Tribol., 129(1) (2007) 84-90. [11] T. Cousseau, M. Björling, B. Graça, A. Campos, J. Seabra, R. Larsson, Film thickness in a ballon-disc contact lubricated with greases, bleed oils and base oils, Tribol. Int., 53 (2012) 53-60. [12] K. Zhang, X. Peng, Y. Zhang, H. Zhou, M. Ma, Numerical thermal analysis of grease-lubrication in limited line contacts considering asperity contact, Tribol. Int., 134 (2019) 372-384. [13] Z. Wang, X. Shen, X. Chen, D. Tao, L. Shi, S. Liu, Experimental investigation of EHD grease lubrication in finite line contacts, Friction, 7(3) (2019) 237-245. [14] L.L.X. Augusto, A. Sinatora, C.O.R. Negrão, T. Cousseau, A numerical investigation of grease friction losses in labyrinth seals, Tribol. Int., 141 (2020) 105958. [15] B.K. Karthikeyan, M. Teodorescu, H. Rahnejat, S.J. Rothberg, Thermoelastohydrodynamics of grease-lubricated concentrated point contacts, Proceedings of the Institution of Mechanical Engineers, Part C: J. Mech. Eng. Sci., 224(3) (2009) 683-695. [16] C.J.A. Roelands, W.O. Winer, W.A. Wright, Correlational aspects of the viscosity-temperaturepressure relationship of lubricating oils (Dr In dissertation at Technical University of Delft, 1966), J. Lubrication Tech., 93(1) (1971) 209-210. [17] B.J. Hamrock, S.R. Schmid, B.O. Jacobson, Fundamentals of Fluid Film Lubrication, New York: Marcel Dekker, Publisher, (2004). [18] M. Kaneta, T. Ogata, Y. Takubo, M. Naka, Effects of a thickener structure on grease elastohydrodynamic lubrication films, Proceedings of the Institution of Mechanical Engineers, Proc. I. Mech E. Part J: J. Eng. Tribol., 214(4) (2000) 327-336. [19] F. Cyriac, P. Lugt, R. Bosman, C. Padberg, C. Venner, Effect of thickener particle geometry and concentration on the grease EHL film thickness at medium speeds, Tribol. Lett., 61(2) (2016) 18. | ||
|
آمار تعداد مشاهده مقاله: 340 تعداد دریافت فایل اصل مقاله: 387 |
||